Our Air Conditioning Services

Conrad handles emergency AC repair, maintenance, and installation for homeowners across Portland Metro — all in-house, all major brands, no subcontractors.

Fast diagnosis and same-day availability — Conrad services central AC, heat pumps, and ductless mini splits for homeowners across Portland Metro. All major brands. Written diagnostic report after every visit so you know exactly what was found and fixed.

Seasonal tune-ups, coil cleaning, condensate drain flush, and filter checks — the service visits that prevent emergency repair calls. Schedule AC maintenance before the cooling season starts and avoid summer breakdowns.

New system sizing and installation using a proper load calculation — SEER2-rated equipment matched to your home, not just square footage. See all AC installation options Conrad offers.

Signs Your Central AC Needs Professional Repair

Warm air from vents is the obvious signal — but most AC problems appear earlier. Short cycling (system runs briefly then shuts off before the house cools) often points to refrigerant or airflow restriction. Ice on the refrigerant lines means low charge — not a reason to keep running. Hissing indicates refrigerant escaping; grinding or banging points to a bearing or loose component.

Water pooling near the indoor unit is usually a blocked condensate drain — Oregon’s damp climate means algae builds in drain lines year-round, not just summer. Spring pollen also clogs evaporator coils faster in this region than drier markets, creating airflow restriction that gets misdiagnosed as low refrigerant.

What Conrad’s Central AC Repair Diagnostic Covers

Capacitor and contactor failures are the most common single-visit repairs — stockable parts that cause sudden shutdowns or hard starts. Conrad also handles refrigerant leaks and recharge (R-410A standard; R-22 units are often better replacement candidates), condenser fan motor and blower motor replacement, iced evaporator coils, condensate drain clearing, and thermostat and control board diagnostics.

Central AC Repair or Replace: How to Decide

A stuck reversing valve delivers heating when you’ve called for cooling — the most common heat pump-specific failure. Conrad diagnoses reversing valve issues, refrigerant charge, defrost board problems, and coil condition on heat pump systems in cooling mode. Cooling-mode diagnosis is distinct from heating-mode; Conrad checks both on every service call.

Central AC Repair Cost in Beaverton, OR

For commercial clients, a failed AC unit carries real costs. A restaurant kitchen at 90°F is a food safety issue. A medical office without cooling faces patient safety and regulatory concerns. A retail space loses customers by the hour on a 95°F July day. Portland Metro’s summer heat events now run multiple days — commercial buildings are exposed faster than residential properties.

Conrad offers emergency dispatch 24/7 across Beaverton and Portland Metro. Stocked trucks mean most common commercial AC failures — capacitor, contactor, refrigerant charge — get resolved on the first visit.

Schedule Central AC Repair Today.

Every service call starts with a systematic diagnosis — not a symptom-based guess. Conrad’s technician checks thermostat signal output, runs refrigerant pressure at suction and discharge (low suction = refrigerant loss or restricted airflow; high discharge = dirty condenser coil or failed outdoor fan), and measures amp draw on compressor and fan motors. That 20–30 minute assessment is what separates a correct fix from a parts swap that misses the root cause.

Findings are explained in plain language before any work starts — what’s wrong, what it costs, and whether repair or replacement makes more sense. Same-visit repair wherever parts are on the truck. Larger replacements quoted with a clear timeline. Written diagnostic report before the technician leaves.

A clear rule: if repair cost exceeds 50% of replacement cost and the unit is over 10–12 years old, replacement is usually the better investment. Oregon-specific triggers sharpen that decision. R-22 refrigerant systems — any unit installed before 2010 — are expensive to recharge because R-22 is no longer manufactured. Systems with a SEER rating below 13 don’t meet the current Pacific Northwest minimum of 13.4 SEER2. Repeat failures in one cooling season signal system-wide degradation.Older Portland Metro homes — many with original systems from the mid-2000s — are at or past that decision point. Conrad provides an honest assessment at every diagnostic visit. See central AC installation if replacement makes more sense.

Why Choose Conrad for Your Central AC Repair?

Expert Technicians

Conrad’s technicians are CCB licensed and EPA608 certified — the federal refrigerant certification required by law for anyone handling or charging refrigerant. Every tech is background-checked and trained across all major AC brands: Lennox, Carrier, Trane, Daikin, Goodman, Rheem, and Bosch. Conrad is an authorized Bosch dealer. The technician who shows up is a Conrad employee — not a subcontractor dispatched from a third-party network.

Prompt Service

When a home AC fails during a Portland Metro heat event, same-day service is a health matter — not just a comfort issue. Conrad offers same-day scheduling across Portland Metro and emergency dispatch 24/7. Service trucks carry capacitors, contactors, refrigerant, and other frequently replaced components so most AC calls get resolved on the first visit, without parts-ordering delays.

Everything In-House

Conrad handles emergency AC repair, seasonal maintenance, and full system installation — all within one licensed team, no third-party handoffs. If a repair call reveals the system is past its useful life, the same technician who diagnosed the problem can walk through replacement options and handle the installation. One company, one team, from the initial call to the written report.

Customer-Centric Approach

Every service call closes with a written diagnostic report — not just a receipt. It details what was found, what was repaired, what parts were used, and what to monitor. The flat-rate price is communicated and confirmed before any work begins. If repair doesn’t make financial sense given the system’s age and condition, Conrad says so directly, with the data to back it up.

How long does central AC repair take?

Most diagnostics take 45 minutes to an hour. Repair time depends on the failure — a capacitor swap takes 15–20 minutes; a refrigerant leak repair and recharge takes 1–2 hours; condenser fan motor replacement runs 45–90 minutes. Conrad provides a time estimate with the flat-rate quote.

Can Conrad repair central AC on all brands?

Yes. Conrad’s EPA608-certified technicians service all major central AC brands — Bosch (authorized dealer), Lennox, Carrier, Trane, Daikin, Goodman, Rheem, American Standard, and others. Older systems are serviceable as long as parts are available; R-22 refrigerant is still obtainable for older systems, though the cost is significantly higher than R-410A.

What’s included in Conrad’s central AC diagnostic?

Refrigerant pressure testing, temperature differential across the evaporator coil, capacitor and contactor testing under load, coil condition, condensate drain line inspection, static pressure reading, and thermostat communication check. Findings are documented in a written report provided at the end of every visit.

When should I replace instead of repair my central AC?

When the repair cost exceeds 30–40% of a new system’s installed price, or when the system is 12+ years old with a sub-14 SEER rating and needs a significant repair. R-22 refrigerant systems almost always tip toward replacement when a refrigerant-requiring repair is needed. Conrad provides a written cost comparison at every diagnostic visit.

Does Conrad offer same-day central AC repair?

Yes. Same-day repair is available across Beaverton and Portland Metro when scheduling allows. For urgent cooling failures that can’t wait — system won’t start, blowing warm air during a heat event — Conrad’s emergency AC repair line runs 24/7.